???? Free Shipping Over 100 AED ????
How to Make the Bracelet
- Beginner
- 10 Minutes
- 6 Materials
Required Tools
Jinro Smooth Chain Nose Jewelry Pliers
Jinro Flush Cutter
Curved Precision Tweezers
Jinro Serrated Chain Nose Pliers
Image of Final Product
Materials & Tools You'll Need
Everything required to create this beautiful bracelet • Hover for details
Step-by-Step Instructions (4 Step)
1
Prepare the Wire
Step 1:
Cut approximately 35 to 40cm of beading wire. Thread one end through valve stopper bead and add jump ring to the wire.
Tip:
2
Secure the Stopper Bead
Step 2:
Fold the wire back and pass it again through the stopper. Using needle-nose pliers, gently press the valve until it is fixed in place.
Tip:
Make sure that you push valve completely and it is tight.
3
Adding Beads
Step 3:
Thread your beads onto the wire according to your design, including spacer beads and different stone beads.
Tip:
4
Finish the Other End
Step 4:
Repeat the same process as the first side and add extension part of clasp. Now add lobster clasp to the attached jump ring in the first side.
Tip:
Make sure the lobster clasp and the extension chain are attached on opposite sides of the bracelet for proper fastening and balance. Your bracelet is now complete—elegant, coordinated, and beautifully handcrafted!
