???? Free Shipping Over 100 AED ????
Step-by-Step Multi-Pendant Bracelet Guide
- Beginner
- 15 Minutes
- 10 Materials
Required Tools
Jinro Smooth Chain Nose Jewelry Pliers
Curved Precision Tweezers
Jinro Serrated Chain Nose Pliers
Image of Final Product
Materials & Tools You'll Need
Everything required to create this beautiful bracelet • Hover for details
Step-by-Step Instructions (6 Step)
1
Step 1
Cut approximately 35 to 40 cm of beading wire. Thread one end of the wire through a knot cover and then through a regular stopper bead.
Tip:
2
Step 2
Fold the wire back and pass it again through the knot cover. Using needle-nose pliers, gently press the stopper to secure it in place.
Tip:
Be careful not to apply too much pressure, as this may cause the stopper bead to break.
3
Step 3
Position the stopper exactly in the center of the knot cover. Then close the cover carefully so that the stopper bead is hidden inside. This will give your work a clean and professional finish. Finally, add a lobster clasp to the first knot cover.
Tip:
4
Step 4
Then begin threading your beads and spacer beads onto the wire in desired order or following your design.
Tip:
5
Step 5
Once all components are in place, repeat all the process like the first side, but add a jump ring to the second knot cover due to fasten the clasp.
Tip:
For added strength and durability, pass the excess wire back through the first bead and trim any remaining wire carefully to complete your necklace.
6
Step 6
Finally, add 3 charms which are attached to separate jump rings to a bigger jump ring and link it to the center of wire. This location is subject to change and depends on your taste. your bracelet is now complete!
Tip:
