???? Free Shipping Over 100 AED ????
How to Make the Bracelet
- Beginner
- 15 Minutes
- 8 Materials
Required Tools
Jinro Round Nose Pliers
Jinro Smooth Chain Nose Jewelry Pliers
Curved Precision Tweezers
Image of Final Product
Materials & Tools You'll Need
Everything required to create this beautiful bracelet • Hover for details
Step-by-Step Instructions (6 Step)
1
Step 1
Cut approximately 35 to 40cm of beading wire. Thread one end through a knot cover and then through a stopper bead.
Tip:
2
Step 2
Fold the wire back and pass it again through the knot cover. Using needle-nose pliers, gently press the stopper bead until it is fixed in place.
Tip:
Be careful not to over-press, as it may break. Position the stopper bead in the center of the knot cover and close it carefully to conceal it and achieve a polished finish.
3
Step 3
Attach extension part of lobster clasp to the first knot cover.
Tip:
4
Step 4
Thread your beads onto the wire according to your design, including spacer beads and a Van Cleef in the center.
Tip:
5
Step 5
Repeat the same process as the first side and add lobster clasp to second knot cover.
Tip:
6
Step 6
Make sure the lobster clasp and the extension chain are attached on opposite sides of the bracelet for proper fastening and balance.
Tip:
Your bracelet is now complete—elegant, coordinated, and beautifully handcrafted!
