How to Make a Bracelet with a T-Bar Clasp

Prepare the Wire

Step 1:

Cut approximately 35 to 40cm of beading wire. Pass one end of the wire through a knot cover and then through a stopper bead.

Secure the Stopper Bead

Step 2:

Loop the wire back and pass it again through the knot cover. Using flat-nose pliers, gently press the stopper to secure it in place. Position the stopper bead neatly in the center of the knot cover, then close the cover completely so the crimp is hidden inside. This step gives your bracelet a clean, professional look.

Attach the T-Bar Clasp (First Side)

Step 3:

Open the T-bar clasp. Using a jump ring, add your chosen decorative charm to the clasp(the ring side, which already has a loop). attach this part of the clasp to the first knot cover by a jump ring.

Add Beads

Step 4:

Now begin threading your beads onto the wire. Follow your desired design or pattern, adding beads and spacer beads in the same order as shown in your reference

Finish the Second Side

Step 5:

Once all beads are in place, repeat the same process as the first side: • Pass the wire through a knot cover and stopper • Loop the wire back • Secure the stopper with pliers • Close the knot cover neatly

Attach the Clasp (Second Side)

Step 6:

Finally, attach the second part of the T-bar clasp to the knot cover.