???? Free Shipping Over 100 AED ????
Now we are going to assemble the double-strand bracelet.
- Intermediate
- 20 Minutes
- 8 Materials
Required Tools
Jinro Smooth Chain Nose Jewelry Pliers
Curved Precision Tweezers
Jinro Serrated Chain Nose Pliers
Image of Final Product
Materials & Tools You'll Need
Everything required to create this beautiful bracelet • Hover for details
Step-by-Step Instructions (8 Step)
1
Step 1:
Cut about 20-25 cm of beading wire. Pass it through a knot cover and a regular stopper bead. Loop the wire back and pass it again through the knot cover. Then, using pliers, gently press the stopper to secure it.
Tip:
Be careful not to apply too much pressure, as it may break.
2
Step 2:
Position the stopper neatly inside the knot cover and close it, so the stopper is hidden and the finish looks clean.
Tip:
3
Step 3:
Open the T-bar clasp and attach one part of it to the knot cover, using a jump ring.
Tip:
4
Step 4:
Following the order shown in the video, start threading spacer beads and natural pearls onto the wire.
Tip:
5
Step 5:
At the end, repeat the same process as the first side: secure the wire with a stopper bead and knot cover. Then, using a jump ring, attach a beautiful oval link to the knot cover.
Tip:
6
Step 6:
Cut another 35-40 cm of beading wire. repeat the initial steps, attaching the second part of the T-clasp to one end of the new strand, filling it with smaller pearls and leaving the other end free with a knot cover.
Tip:
7
Step 7:
Pass the thinner strand through the oval link.
Tip:
8
Step 8:
Then connect and close the knot cover to T-clasp jump ring. “Your beautiful piece is now ready to wear!”
Tip:
