Step-by-Step Double Layer Chain Bracelet Guide

Step 1:

Cut a piece of wire rope approximately 30 to 35cm in length. Thread one end of the wire through a valve stopper bead. Add jump ring to the wire. Loop the wire back and pass it again through the stopper bead.

Step 2:

Using needle-nose pliers, gently press the valve of the stopper until it is securely closed, fixing both the clasp ring and the wire in place.

Step 3:

Begin threading the beads and spacer beads onto the wire, following your desired design or the sequence shown in your reference.

Step 4:

Once all components are in place, thread a second stopper bead and jump ring to the wire. Loop the wire back through the stopper bead, just as you did on the first side, and secure it firmly by pressing the valve.

Step 5:

Now attach one side of this piece to the first side of your chosen connector.

Step 6:

Repeat this method and make another piece exactly like the first one. Connect it to the second side of the connector.

Step 7:

Add extension part and lobster clasp to jump rings, which were added to opposite sides of bracelet.

Step 8:

Cut approximately 30 to 35cm of your pre-selected chain and add 2 jump rings to both sides of that and attach it to both sides of pre-assembled bracelet. then add a teardrop crystal charm to the center of chain, using a jump ring.