???? Free Shipping Over 100 AED ????
Step-by-Step Necklace Guide with Stainless Chain
- Intermediate
- 20 Minutes
- 8 Materials
Required Tools
Jinro Serrated Chain Nose Pliers
Jinro Smooth Chain Nose Jewelry Pliers
Jinr
Curved Precision Tweezerso Flush Cutter
Image of Final Product
Materials & Tools You'll Need
Everything required to create this beautiful bracelet • Hover for details
Step-by-Step Instructions (7 Step)
1
Prepare the Wire
Step 1:
Cut approximately 15cm of beading wire. Thread one end of the wire through a knot cover and then through a regular stopper bead.
Tip:
2
Secure the Stopper Bead
Step 2:
Fold the wire back and pass it again through the knot cover. Using needle-nose pliers, gently press the crimp bead to secure it in place.
Tip:
Be careful not to apply too much pressure, as this may cause the crimp bead to break.
3
Hide and Finish the Knot
Step 3:
Position the stopper exactly in the center of the knot cover. Then close the cover carefully so that the stopper bead is hidden inside. This will give your work a clean and professional finish.
Tip:
4
Step 4:
Cut two pieces of your chosen chain, each approximately 15 cm long. Attach one end of pre-selected chain to the knot cover, using a jump ring. Now on the other side of chain, add a jump ring to let the clasp fasten.
Tip:
5
Step 5:
Then begin threading your beads onto the wire in desired order or following your design.
Tip:
6
Finish the Other Side
Step 6:
Once all beads are in place, thread the wire through a knot cover and then through a regular stopper bead and repeat the same process from Step 2.
Tip:
7
Attach Second Chain
Step 7:
Add other chain to the second knot cover and on the other side of chain, attach a jump ring and clasp.
Tip:
Your necklace is now complete—beautiful, balanced, and professionally finished!
