???? Free Shipping Over 100 AED ????
Step-by-Step Pendant Bracelet Guide
- Intermediate
- 20 Minutes
- 8 Materials
Required Tools
Jinro Smooth Chain Nose Jewelry Pliers
Jinro Flush Cutter
Curved Precision Tweezers
Jinro Serrated Chain Nose Pliers
Image of Final Product
Materials & Tools You'll Need
Everything required to create this beautiful bracelet • Hover for details
Step-by-Step Instructions (5 Step)
1
Step 1:
Cut a piece of wire rope approximately 50 to 55 cm in length. Thread one end of the wire through a valve stopper bead and add the lobster clasp to the wire. Loop the wire back and pass it again through the stopper bead.
Tip:
2
Step 2:
Using needle-nose pliers, gently press the valve of the stopper until it is securely closed, fixing both the clasp ring and the wire in place.
Tip:
3
Step 3:
Begin threading the beads and spacer beads onto the wire, following your desired design or the sequence shown in your reference.
Tip:
A wide range of options is available on this website
4
Step 4:
Once all components are in place, thread a second stopper bead and jump ring onto the wire. Loop the wire back through the stopper bead, just as you did on the first side, and secure it firmly by pressing the valve.
Tip:
For added strength and durability, pass the excess wire back through the first bead and trim any remaining wire carefully to complete your necklace.
5
Step 5:
Take the two pre-selected charms that are already attached to separate jump rings, thread them onto a larger jump ring, and then secure the larger jump ring to the loop of the lobster clasp.
Tip:
