???? Free Shipping Over 100 AED ????
Step-by-Step Pendant Necklace Guide
- Beginner
- 15 Minutes
- 7 Materials
Required Tools
Jinro Serrated Chain Nose Pliers
Jinro Smooth Chain Nose Jewelry Pliers
Jinro Flush Cutter
Curved Precision Tweezers
Image of Final Product
Materials & Tools You'll Need
Everything required to create this beautiful bracelet • Hover for details
Step-by-Step Instructions (4 Step)
1
Step 1:
Cut a piece of wire rope approximately 55 to 60 cm in length. Thread one end of the wire through a valve stopper bead. Add a jump ring to the wire. Loop the wire back and pass it again through the stopper bead. Using needle-nose pliers, gently press the valve of the stopper until it is securely closed, fixing both the ring and the wire in place.
Tip:
2
Step 2:
Begin threading the beads and the pendant onto the wire, following your desired design or the sequence shown in your reference. Make sure that the pendant is located in the middle of necklace exactly.
Tip:
3
Step 3:
Once all components are in place, thread a second stopper bead onto the wire. Loop the wire back through the lobster clasp and again pass it to stopper bead, just as you did on the first side, and secure it firmly by pressing the valve.
Tip:
For added strength and durability, pass the excess wire back through the first bead and trim any remaining wire carefully to complete your necklace.
4
Step 4:
Add extension part of the clasp to the pre-attached jump ring in the first side.
Tip:
“Your beautiful piece is now ready to wear!”
